Apply an all-over coat of White Primer, once thoroughly dry follow it with a coat of Satin White. Mask off the end panel and spray it with Satin Lemon.

When dry, measure the crib's end panel, and work out where its center point is. Mark the point with a pencil.

Use masking tape to mark out a square measuring 20cm × 20cm, convert to inches making sure its center point is the point you marked earlier. Protect the rest of the panel with masking tape and newspaper, and spray with Satin Pastel Green.

While the paint is drying, cut a circle from a sheet of thick paper measuring 10cm in diameter. Once everything has dried, use Repositional Adhesive to place the paper in the center of the green square, leaving all the masking tape and newspaper in place. Press the edges of the circle down firmly.

Spray a light coat of Satin Orange on the exposed green area .While the paint is still sticky (this stops the paint from being pulled up as you remove the tape), peel off the circle and the rest of the paper and masking tape.

Note: Always follow usage instructions on the reverse of Valspar spray paint cans.